• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

Yippee! What the postman brought

WMcNabb

150cc
Was sleepy surfing the other night and came across a post for these little beauties.
$10 for 30 clips, which should last me a while.
Great fit, and better design than the ones I have been using previously.
 

Attachments

  • 49EE150C-589F-4961-A7BA-79CB9FDC24C4.jpeg
    49EE150C-589F-4961-A7BA-79CB9FDC24C4.jpeg
    298.1 KB · Views: 202
  • FEFE7FE7-5541-465C-B743-2999951553E6.jpeg
    FEFE7FE7-5541-465C-B743-2999951553E6.jpeg
    222.9 KB · Views: 214

AKNick

640cc Uber Pimp
Was sleepy surfing the other night and came across a post for these little beauties.
$10 for 30 clips, which should last me a while.
Great fit, and better design than the ones I have been using previously.

I've been switching to heat shrink. I dont like how most of the servo lead clips can rub against the wires. If I cannot use a heat gun, I'll use those exact clips.
 

Snoopy1

640cc Uber Pimp
I've been switching to heat shrink. I dont like how most of the servo lead clips can rub against the wires. If I cannot use a heat gun, I'll use those exact clips.
What have you found about the clips. Do they damage the wire , would like to know if I am doing something wrong.
 

AKNick

640cc Uber Pimp
What have you found about the clips. Do they damage the wire , would like to know if I am doing something wrong.

They are fine. I've never had a failure due to one. Just noticed the plastic rubbing into the insulation a couple times - heat shrink wont do that, or ever come off, and is thin enough without sharp edges to slip inside snakeskin looming easier. So it's personal preference.
 

WMcNabb

150cc
They are fine. I've never had a failure due to one. Just noticed the plastic rubbing into the insulation a couple times - heat shrink wont do that, or ever come off, and is thin enough without sharp edges to slip inside snakeskin looming easier. So it's personal preference.

Clips are a bit of a pain to slip inside the snakeskin, but I typically put a piece of painters tape around the clip to avoid snagging the skin.
Primary place I’m using clips is at each wing servo connection on the Python.
Was using a box and tie wrap over the connection, but decided to try this different style.
Haven’t found a good method of mounting solid connectors for the lower wings, but I’m still studying that one.
 
Last edited:

Snoopy1

640cc Uber Pimp
They are fine. I've never had a failure due to one. Just noticed the plastic rubbing into the insulation a couple times - heat shrink wont do that, or ever come off, and is thin enough without sharp edges to slip inside snakeskin looming easier. So it's personal preference.
I agree with you about snakeskin the only thing I do differently is i also take off the servo wire connector then connect the pins and heat- shrink the wires. And it is easy to put all back to how it was if needed.
 
Top