• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

Help! Making landing gear

Alky6

150cc
Trying to understand the picture of the landing gear. Could you take a picture from the front. Just look at how the gear will carry the load or impact. Looks like three legs going to either wheel. Would like to see how the centre leg is supported and how it is connect to the plane. But just for reference you mentioned that you are trying to wrap or bend the wire around the axel. If I understand you correctly and I understand the gear setup then I would use piano wire but at the location of the axel just heat it up to a very dull red in the dark and wrap it around the axel. At that location the strength of piano wire is not required and the loss of some strength due it a little stress relief will not in way comprise the strength of the gear. But please understand that a can not see exactly how the gear is put together. Just trying to help.
That is definitely another way around it (heating it) and easy. Probably much easier than trying to source different materials.
 

49dimes

Damn I'm hungry
Wow that is one good looking tool . That should do the job let us know how it works when you get it.

Maybe @acerc will let us know. I may or may not get one. Depends on how well I can straighten back the right side of the Cub gear :concern:.
Besides....Already blew my allowance trying to get that cool saw ;).
 

acerc

640cc Uber Pimp
Ok Fella's, the Universal bender showed up. First impressions was when I picked the box up and thought wholly crap. I figured by the low price it might be a very light weight and low grade piece of equipment, no where near capable of bending 5/16 piano wire. After opening I see why it is heavy, this is one nice tool. The design kind of reminds me of a mechanical bender I used many years ago. It has a number of sized circular blanks as well as a couple angled blanks. I have no doubt this little tool will bend anything I throw it's way. Thanks @49dimes for finding and sharing it with us.
Forgive the hideous paint table used to photo on but all my others are over flowing.
 

Attachments

  • P1080709.JPG
    P1080709.JPG
    423.2 KB · Views: 357

acerc

640cc Uber Pimp
Do a short video of it working.
Can't right now, busy getting other things done. I have one week to finish preparing before Tog Gun and the following week Joe Nall.
And in the mix of these things the wife and I are nursing her mother through the last days of a battle with cancer. Might not make either of those events depending on how it goes with her.
 

pawnshopmike

Staff member
Can't right now, busy getting other things done. I have one week to finish preparing before Tog Gun and the following week Joe Nall.
And in the mix of these things the wife and I are nursing her mother through the last days of a battle with cancer. Might not make either of those events depending on how it goes with her.

Ugh. Best of luck bro.
 
Top