The 'What did you do in your workshop tonight?' thread

[49dimes]

Got to play a bit more with the iX12 and custom fit some photos to the models memory. I thought this picture was most fitting for the cub.

 

[pawnshopmike]

Working on some doors for my daughter’s entertainment center.

 

[dhal22]

Finished the landing gear area repair on my 540 today. Back to the rc trailer it went.

 

[Alky6]

Re-maiden with vid?

 

[Alky6]

Better?
What a Radio! It even captures my very being .

View attachment 109781
View attachment 109781 View attachment 109782 View attachment 109783 View attachment 109784 View attachment 109785 View attachment 109786 View attachment 109787 View attachment 109788 View attachment 109789 View attachment 109790

Looking forward to your reports on how the tx works out for you.

 

[49dimes]

Looking forward to your reports on how the tx works out for you.

My first thoughts....Not a really hard learning curve. Loads of "Tutorials" available. A unique and very attractive radio.

 

[pawnshopmike]

Almost done with the entertainment center. Just have to install the rollers on the doors. Should have it wrapped up today.

 

[Snoopy1]

Almost done with the entertainment center. Just have to install the rollers on the doors. Should have it wrapped up today.

View attachment 109828

That did not take to long but it does look good. I thing it will be great in the workshop plenty of storage and nice flat top to work off.

 

[pawnshopmike]

Done!

 

[pawnshopmike]

That did not take to long but it does look good. I thing it will be great in the workshop plenty of storage and nice flat top to work off.

I don't know about the workshop. It's only 24" tall so not back friendly to work off of. But it's going to look great in my daughter's living room.