Cool Charging cases!!! What are you guys using?????

[JC 3D]

I'm wrapping up a single charger / bump controller build in a more compact format.

Should be done later his week and I will post a photo or three when it is finished.

JC

 

[JC 3D]

Okay - it's complete!

My new ultimate super duper compact portable charging station...

Inside:
PowerLab 6 - qty 1
Bump Controller - qty 1
Digiland DL1008M 10.1 tablet - qty 1
Digital Temperature (internal) - qty 1Plastic Deck (1/8") - qty 1
24 volt Power Supply - Two DPS-1200FB in series
80 mm Cooling Fan (exhaust) - qty 1
Wires - a hole bunch of them
Various jacks, connectors, and extensions

Outside:
Digital Voltage (power supply) - qty 1
Dual USB Outputs - qty 1
Y power cable - qty 1
55 mm filtered fan grilles (intakes) - qty 4
80 mm wire fan grille exhaust - qty 1

Photos below (sorry for the poor quality)

Let me know what you think of it.

JC

 

[pawnshopmike]

Okay - it's complete!

My new ultimate super duper compact portable charging station...

Inside:
PowerLab 6 - qty 1
Bump Controller - qty 1
Digiland DL1008M 10.1 tablet - qty 1
Digital Temperature (internal) - qty 1Plastic Deck (1/8") - qty 1
24 volt Power Supply - Two DPS-1200FB in series
80 mm Cooling Fan (exhaust) - qty 1
Wires - a hole bunch of them
Various jacks, connectors, and extensions

Outside:
Digital Voltage (power supply) - qty 1
Dual USB Outputs - qty 1
Y power cable - qty 1
55 mm filtered fan grilles (intakes) - qty 4
80 mm wire fan grille exhaust - qty 1

Photos below (sorry for the poor quality)

Let me know what you think of it.

JC

Great job brother. Mikey like!