Discussion Choosing an air frame----frustrations!

[SnowDog]

Would these servos be comparable to the Hitec 7245's?

http://helipartsdirect.com/kst-ds515mg-high-voltage-digital-servo-model-ds515mg.html

 

[gyro]

Would these servos be comparable to the Hitec 7245's?

http://helipartsdirect.com/kst-ds515mg-high-voltage-digital-servo-model-ds515mg.html

A little less torque, since they're 76 oz-in at 7.4v compared to 88 oz-in on the Hitec, but they're still a nice improvement over the 5245mg and as a bonus they're HV.

 

[Dr. Gonzo]

Not bad looking numbers. Fast too!

 

[Buick Mackane]

Here are some. [MENTION=646]cwojcik[/MENTION] has the RJX version of this servo. We have both toned down our BECs as there is only so much stupid fast you need.

[video=youtube;o3WqLdl0N3g]https://www.youtube.com/watch?v=o3WqLdl0N3g[/video]

[video=youtube;2yeHpiby1dU]https://www.youtube.com/watch?v=2yeHpiby1dU[/video]

SWEEEEEET! that snap loop with the tail drag was AWESOME! Great flights! Thanks for posting them

 

[bbrown2828]

man the power on the 60 inch laser is unreal

 

[Enterprise]

Ours have the Torque motors. Apparently the Motrolfly 4315-480 is even more. This is my benchmark for stupid power.

 

[SnowDog]

I had the Motrolfly 4315-480 on my 3DHS 58" Edge and it was incredible power on 6S. I'm fixing up an EF 60" Extra right now and the Motrolfly 4315-480 is going in there...I'm sure it will be stupid power as well. Motrofly ROCKS!

 

[Dr. Gonzo]

Cody is running the Torque? More is CRAZY!

 

[Enterprise]

Yes, he is running the Torque. He is sponsored by EF, so he runs their equipment. I got a wicked good deal on my motor. I run a Gecko instead of the Airboss as I run a HV servo setup. If you get the 7245s I would go with the Gecko 85A.

 

[SnowDog]

Agreed....I've got a Gecko 85A paired with my DM4315-480 ready to go!