question for you all IMAC experts.
i was practicing today with my 120" extra 330 LX (3DHS)
and decided to push the limit, and flew one flight for 11 minutes and the 2nd flight for 10.5 minutes. my alarm is set for 10 minutes. and i am using two MTW re3 pipes with DA 170....
usually i will do two sequences in one flight, land, then refuel.
but today, i did 3 sequences in one flight.
before i ask my question,
i am using a PSP cap with PSP fittings, a 1.5 liter Fiji water bottle, and from the cap inside the tank, there is a 3 cm piece of viton, this is then attached to a long brass tube, which then is welded on to a brass clunk, and then the clunk has another piece of Viton that makes contact with the plastic of the inside of the fuel tank.
today, i was doing some real high hammerheads and big reverse 1/2 cuban eights. when i got her back level, towards the end of the flight, (3rd sequence), the motor sounded like it was about to give up. i assume is from air in the lines. sure enough when i landed, the fuel tank had, i would say, about 200 ml's of fuel left.
would any of you change out the tank somehow, or just go back to only 2 sequences?
fuel consumption is 118 ml per minute or 4 ounces per minute. does that sound about right?
i was practicing today with my 120" extra 330 LX (3DHS)
and decided to push the limit, and flew one flight for 11 minutes and the 2nd flight for 10.5 minutes. my alarm is set for 10 minutes. and i am using two MTW re3 pipes with DA 170....
usually i will do two sequences in one flight, land, then refuel.
but today, i did 3 sequences in one flight.
before i ask my question,
i am using a PSP cap with PSP fittings, a 1.5 liter Fiji water bottle, and from the cap inside the tank, there is a 3 cm piece of viton, this is then attached to a long brass tube, which then is welded on to a brass clunk, and then the clunk has another piece of Viton that makes contact with the plastic of the inside of the fuel tank.
today, i was doing some real high hammerheads and big reverse 1/2 cuban eights. when i got her back level, towards the end of the flight, (3rd sequence), the motor sounded like it was about to give up. i assume is from air in the lines. sure enough when i landed, the fuel tank had, i would say, about 200 ml's of fuel left.
would any of you change out the tank somehow, or just go back to only 2 sequences?
fuel consumption is 118 ml per minute or 4 ounces per minute. does that sound about right?