Miracle Switch w/ fuel dot - suggestions needed

[tailskid]

I'd like to install a (I think) Miracle Switch that has the charging port, fuel dot and on/off switch on my Sbach 300 (30cc)....I tried one time to mount this switch and ended up having a difficult time holding it in place because there is very little room for the switch to grab the wood securely. Any suggestions? I made a cardboard template and it sure would be nice to have a plastic 'template' to use as there isn't much wood in the front of the plane to mount this puppy.

13683=7552-1.jpg

13683=7553-2.jpg

13683=7551-back (1).jpg

13683=7550-back (2).jpg

 

[pawnshopmike]

Might try gluing it in with a little clear silicone. Put the screws in to fill the holes and hold it in place till the silicone cures.

 

[siko_flyer]

Add a small piece of wood to give more support.

 

[Madinpensacola]

Yep as above. If it's balsa I'm mounting in then I'll glue in a light ply plate/doubler behind it then recut the mounting hole. Screw it in through the balsa AND ply now. Also not a bad idea that once the screws are in, back them back out, add a small drop of CA glue to harden the hole then screw it all back into it's permanent position. Firms up the screw's bite in the wood.

 

[giddyuperic]

I add the wood and use silicone clear works every time.

 

[tailskid]

Some great ideas there guys....now if only the maker would supply a template......

 

[Robotech]

While you have the clear silicone out, you might want to secure the wires on the back of the switch. They are notorious for breaking loose. Not a good situation.

 

[tailskid]

That is something I had not thought of! Thanks.