Scale Nelitz 1/3 scale Cub build

[dhal22]

Typical of this kit is another incorrect laser cut. Soooo many times over the years I've been stymied by parts that are incorrect. I have lost months looking at incorrect parts until i figure out what to do. As much as i hate to say this, i don't believe Don when he stated that he has sold many of these kits, there are just too many incorrect parts. One would assume they are all correct if many have been sold.

So in my opinion F2A is too thin, there's no way the cowling or the covering would work. I can sand my piece as needed but now the cowl fits and I can see a solution to this area,.

 

[TonyHallo]

The last laser kit I did had many errors, I started to make notes but gave up thinking that someone had reported the errors but they were never corrected in the files.

 

[dhal22]

Getting serious about closing up the fuse. Rudder pedals were too wide so trimmed and re soldered the little cable tabs.

Working the servo/ ignition wires towards the middle of the plane.

 

[dhal22]

Test fitting parts and pieces.

 

[dhal22]

Gluing in the foot pedals tonight.

 

[TonyHallo]

And drinking what beer?

 

[dhal22]

And drinking what beer?

 

[dhal22]

Decision to make. Ignition connection will be inaccessible once i cover the right side. Move the ignition forward or let it be?

Side view photo strategically placed for Tony.

 

[dhal22]

Ignition is movable but in the right spot otherwise.

 

[dhal22]

I have a cute little tachometer readout. And an ignition tachometer wire. This would NOT be scale in my instrument panel.