3D PAU 100cc EXTRA 300sp

[Islandflyer]

AEROSHELDON;20010 wrote: HMMM. I got mine used and did not build it, but I did not see that in the manual I downloaded. I do have a V1 plane though.



Thanks for the info!

All versions should have it; we recommend two servos if you use push-pull: if only one is used, given the high speed and torque of current servos, it can damage the hinges from the "pushing" action.

 

[AEROSHELDON]

Thank you. I am using a BLS177 so I think I will use the pull/pull for a while longer then.

 

[3dbandit]

I should have mentioned this; I am using slightly larger than stock Robart Hinge-points on the rudder to prevent hinge damage.

 

[mjg0808]

Looking good Jacob.

 

[3dbandit]

         I finished running all the wires to the rx.  

 

    

 

          Wheel Pants mounted. I placed a one inch book under the rear of the pants to give the right distance from the ground

 

Pictures are uploading weird 

 

[Dan767]

I've finally had a chance to maiden my PAU Extra300. 3W-110 on KS 86 cans for power with a 26X12N three blade Mejzlik. Futaba sbus servos. I'll be able to get some pictures and post them later. My CG is just a little bit forward for my liking (just on the forward part of the wing tube). It was a blast to maiden the airplane and I'm impressed with the way it fly's.  

 

[Tseres]

Dan767 said
I've finally had a chance to maiden my PAU Extra300. 3W-110 on KS 86 cans for power with a 26X12N three blade Mejzlik. Futaba sbus servos. I'll be able to get some pictures and post them later. My CG is just a little bit forward for my liking (just on the forward part of the wing tube). It was a blast to maiden the airplane and I'm impressed with the way it fly's.  

My CG ended up about 3/4 to the back of the tube. Almost nutral there.

 

[SleepyC]

Such a nice looking and flying plane. Thanks for sharing. Great thread!

 

[stangflyer]

It would be awesome to see some flying videos'. Bring 'em on.

 

[3dbandit]

I'll be sure to have videos once I have the plane flying.

Almost there...

Here's whats left: throttle servo and linkage, cut and baffle cowl, install ignition system,  install fuel system, CG.