Team 3DRCF Jacob "3dbandit" Pollak

[3dbandit]

In Florida, the flying season slows down around August and September due to heat and storms. LET THE BUILDING SEASON BEGIN.

I just received my first plane for this season. PAU 100cc extra 300sp.

 

[AKfreak]

same as Spencer's?

 

[3dbandit]

same as Spencer's?

Yes.

 

[3dmike]

In Florida, the flying season slows down around August and September due to heat and storms. LET THE BUILDING SEASON BEGIN.

I just received my first plane for this season. PAU 100cc extra 300sp.

Right on Right on! PAU does make a nice airframe. Enjoy man!

 

[3dbandit]

Just finished building this...

Can't wait to get some flights in!

 

[AKfreak]

That baby is Nice, and after seeing Spencer and Gabby wring it out, I know it is a great flying plane. I hope she serves you well bro. Dont forget to post some videos of that girl.

 

[3dbandit]

It was really easy to keep the wires lean in this plane. I'm now considering carbon vinyl or a thin carbon sheet to lay across the tray.

 

[AKfreak]

Thats a 35% plane right? Did you use an I-bec or a Opti-Kill setup. Please do explain your setup. AKf

 

[3dbandit]

Thats a 35% plane right? Did you use an I-bec or a Opti-Kill setup. Please do explain your setup. AKf

I am using an opti-kill from horizon/evolution.

I first have the unit plugged into my receiver, then I have a 2s 450mah lipo connected to it. Inline between the kill switch and the ignition I have a castle BEC to regulate down to 5.9v for continuous voltage.


As for overall setup of the plane: I'm using savox 2231's on all the surfaces and a HS-7950 on the throttle. I am using 1.5 inch arms on the ailerons and elevators, 2 inch on the rudder.

I'm running a DA-120, spinning a mejzlik 27x12th.

I am using glacier 2600 mah 2s packs for the RX.

 

[AKfreak]

Thanks for the info. The HS-7950 is 450 oz of torque, a little overkill for a throttle right