The 'What did you do in your workshop tonight?' thread

[kwj48]

I got a little more done on the Stix 60. Ran out of clear, but the rudder is gonna be clear anyway so you get the point.

 

[pawnshopmike]

I got a little more done on the Stix 60. Ran out of clear, but the rudder is gonna be clear anyway so you get the point.


View attachment 49889





View attachment 49888





View attachment 49890

Nice! Mikey like.

 

[Jetpainter]

I got a little more done on the Stix 60. Ran out of clear, but the rudder is gonna be clear anyway so you get the point.


View attachment 49889





View attachment 49888





View attachment 49890

Looks nice!

Those small checkers have a memorizing effect. It's like one of those internet eye tests.

 

[acerc]

You all are going to love this one.
Yesterday I went to fly the Eagle, all went very well with the exception being when I turned on smoke my engine would near die. I have spent all day going over, under, and through everything. Nothing is wrong!!!! After a lengthy conversation with a fellow modeling buddy it finally hit me, I was flipping the choke switch.....
So, that is what I did in my shop today and tonight.

 

[WMcNabb]

You all are going to love this....Nothing is wrong!!!!....I was flipping the choke switch.....

Glad things worked out Robert!

 

[Xpress]

Managed to limp out to the shop and seal up an exhaust leak (long story). Anybody interested in a set of headers and proflow cans for a DA120?

 

[dhal22]

You all are going to love this one.
Yesterday I went to fly the Eagle, all went very well with the exception being when I turned on smoke my engine would near die. I have spent all day going over, under, and through everything. Nothing is wrong!!!! After a lengthy conversation with a fellow modeling buddy it finally hit me, I was flipping the choke switch.....
So, that is what I did in my shop today and tonight.

Ouch.

 

[Flyingjon]

Managed to limp out to the shop and seal up an exhaust leak (long story). Anybody interested in a set of headers and proflow cans for a DA120?

Now for the long story? [emoji6]

 

[ericrs]

Worked on the Viper tonight! Got the Turtle deck, belly pan, and canopy sheeting cut to size and taped together ready for vacuum bagging!! Thinking I might be able to get those things in the bag tomorrow.

 

[Robotech]

I got started on covering the turtle deck. Damn. I officially hate covering turtle decks. I was a little concerned about getting a clean border between the white and red so I taped a long piece of poster board along the line of demarcation. Then I worked the covering down all the way to and over the edge of the poster board. After I made sure the covering was stuck down good I got the little seam where it transitioned over the poster board as small as possible. Then I laid a long metal ruler op top of the covering and pinched it up against the edge of the now covered poster board edge and made a the cut with a new blade between the two. Orthobird suggested doing only one side then taking a beer break. I substituted with whiskey.