Tundra problem

[Alky6]

I just went and checked on my dx-9. With throttle cut enabled, the throttle won’t move in the monitor. Here are two screen shots showing where it is at, just in case. I know you’re a Futaba guy.

 

[dhal22]

Let me look for throttle cut tomorrow, thx.

 

[Wild man]

I would do what Alky6 advised start with a clean new model. One of my student Pilots had me test fly a 3D Extreme Flight bird for him and the throttle didn't work I discovered the guy that set it up for him programmed a throttle hold and designated switch H on his DX9 trans, as most Heli pilots do, some times you need to rebind if this happens. the other thing if none of this works you may have a bad ESC you should check polarity on the throttle connector if inserted wrong throttle will not work. just saying it is easy to look over the easy stuff I have done it myself when in a hurry. with a throttle cut or hold on or activated the Monitor will not move the bar when the throttle stick is moved up and down. good luck

 

[BalsaDust]

I had posted a response in another thread about this but seeing as your not getting any movement on the monitor page I would dig deeper into your radio setup first.

 

[dhal22]

More planes than i can get to in a day, I'll get to this tomorrow.

 

[dhal22]

Throttle cut, throttle curve, I tried a lot tonight, no luck. I think I'll call Spektrum tomorrow.

 

[dhal22]

Success! Tech support quickly walked me through throttle inhibit and cut. Now to go fly this tundra that's been gathering dust for months.

 

[BalsaDust]

Success! Tech support quickly walked me through throttle inhibit and cut. Now to go fly this tundra that's been gathering dust for months.

Have fun with it.

 

[pawnshopmike]

Success! Tech support quickly walked me through throttle inhibit and cut. Now to go fly this tundra that's been gathering dust for months.

 

[Wild man]

I set up a throttle hold on all my electric plane’s jet’s and my heli’s. A very good feature to add. Everybody at one time or another has accidentally bumped there throttle stick. Glad to here Horizon techs helped you get it right Now go fly and have fun