3D Wiring Idea Photographs

[hbollier]

I am looking for photographs of really awesome electric installations.

I am setting up an Extreme Flight 78" Extra on 12S and I am looking for some ideas to make the wiring install neater.

What I am thinking is to extend the battery lead on the ESC (yes I will install a Cap pack and twist the wires) and mount my plug through the floor of the battery tray with a flush mount somewhere around the wing tube. I would plug my series harness into the flush mount plug in the floor. Having the plug allows me to run a watt meter on the entire system and makes it easier to tap in to the harness for the BEC Pro.

I might even consider going through the side wall. If anyone has photographs of something along those lines, I would appreciate the ideas.

 

[pawnshopmike]

Here you go. Not an electric plane but you get the idea. My uncle Bill's new 3DHS Edge. Everything Bill does is uber clean.

 

[hbollier]

This is a good start, thanks pawnshopmike.

 

[IMAC FANATIC]

 

[IMAC FANATIC]

Ooops, sorry didn't see the 12s part.

 

[hbollier]

Ooops, sorry didn't see the 12s part.

That's OK, you never know where the right idea may come from.

 

[pawnshopmike]

This is a good start, thanks pawnshopmike.

No problem bro.

 

[hbollier]

Well, after all the fretting, I just went ahead and did this.

 

[SleepyC]

This is one of my last NICE jobs on a plane, you can see the DA-100 header to orient the shot.
Not really sure why I lost this plane. Still think it was a radio lockout.

 

[hbollier]

This is one of my last NICE jobs on a plane, you can see the DA-100 header to orient the shot.
Not really sure why I lost this plane. Still think it was a radio lockout.

View attachment 16223

You antenna orientation looks correct so i dont think it was loss of signal. You may be a tad over on wire length so I would go with voltage drop causing brown out.