60" Laser-EXP

[YellowJacketsRC]

Meanwhile, I have a very large box to go unpack

 

[3dbandit]

I have had many digitals do that. I just put a small piece of the fussy side of velcro in between the balance tab and the stab and that fixes it. Very common problem and very common solution.

These not only shake when centered, they twitch at all deflections.

BTW, I am up to 4 failed servos of the 5 Spektrum 5060's that I have purchased.

 

[3dbandit]

Almost done, just waiting on replacement servo's from horizon...

 

[gyro]

Almost done, just waiting on replacement servo's from horizon...

It needs vinyl

 

[3dbandit]

It needs vinyl

Yes it does...

 

[YellowJacketsRC]

Oh, not good. Hitec 7245 MG?

 

[3dbandit]

Oh, not good. Hitec 7245 MG?

7245 is what was on the prototype laser I flew in Bowling Green, they performed well.

 

[wedoitall]

that's whats going in mine. eventho I may switch out to the ones Cody is using after ive seen that they can hold up

 

[Ohio AV8TOR]

I used 7245's on my Edge on 8.2v and they are awesome and now putting them in my Laser. They have some twitch in the neutral position at times but a little flick of the gimbal and it usually stops. They are fast and really helps with rolling circles.

 

[YellowJacketsRC]

I have been using 7245s for the MXS and the Edge. They have performed flawlessly for me with the exception of some jitters around neutral at times. But I use fussy velcro as a matter of course and all is well.