91" Extra 300-EXP ARF

[dribar]

I still need a set too

 

[dth7]

Post error!

 

[dth7]

I'm running 20ga... Made mine from scratch one is 47" the other is 49". I'm sure you could get away with two 48" ers. My RX is here. View attachment 32638

Rudder arm- 3"? Also like volt meter. Just tied into power lead to Rx? Thnx

 

[Enterprise]

I still need a set too

[MENTION=443]ghoffman[/MENTION] has the printer back up. Send him a PM.

 

[ghoffman]

It is back up and working great. I just printed up some 104 baffles and servo tester mounts. The best thing is to email me. Gshoffman@comcast.net

 

[Zeb Magsi]

Would a DLE 61 be a good engine for this plane? I have always used DLE.

 

[Enterprise]

This plane builds out at 21 or more pounds. DA-60 with a pipe is OK power, but not outstanding. Most do DA-70 or DA-85. One guy I doing a DLE-85 over on the FG thread.

 

[Zeb Magsi]

This plane builds out at 21 or more pounds. DA-60 with a pipe is OK power, but not outstanding. Most do DA-70 or DA-85. One guy I doing a DLE-85 over on the FG thread.

Interesting, I will check on that build thread.

 

[dth7]

Tony at DA steered me toward the 70 and away from the 85 for this airframe. If going that big a single you may want to beef up the airframe a bit. Especially in the motor mount. Just in case! If you think you "Need" more power check out Jase's video. He's on a 70 w mufflers no can no pipe. Dunno but looks like it has plenty pull!
https://m.youtube.com/watch?v=Ml50CMmWatY&list=FLKuCNTGzcffrySHwp62GiyA

This is a piped DA 60-
https://m.youtube.com/watch?v=62B74WkOmcs

Depending on your needs I think a piped 60/ 61 should be fine. I went with the 70 to get into a twin and have a little different throttle curve. Good luck.

 

[Zeb Magsi]

Tony at DA steered me toward the 70 and away from the 85 for this airframe. If going that big a single you may want to beef up the airframe a bit. Especially in the motor mount. Just in case! If you think you "Need" more power check out Jase's video. He's on a 70 w mufflers no can no pipe. Dunno but looks like it has plenty pull!
https://m.youtube.com/watch?v=Ml50CMmWatY&list=FLKuCNTGzcffrySHwp62GiyA

This is a piped DA 60-
https://m.youtube.com/watch?v=62B74WkOmcs

Depending on your needs I think a piped 60/ 61 should be fine. I went with the 70 to get into a twin and have a little different throttle curve. Good luck.

Thank You, I think DA60 would be fine for me as i am new to 3D flying and i am not an expert yet. I might change my mind as i won't be ordering a 91" till July. I just ordered a 48" Extra to play around with.