LED light controller?

[Xpress]

Does someone out there make an LED light controller that I can turn on or off from the receiver? Something preferably that uses a separate power battery than the receiver, since the LED lights I'm planning on using would be on a higher voltage.

 

[Pistolera]

ElectroDynamics does, although not sure how high theirs is rated for voltage. I have one in my Krill for a landing light....works great.

 

[Xpress]

Looks like it can't handle much over 6 volts. That may work with a regulated 2s lipo pack just fine.

 

[Tankd]

I use this on a flat wing foamy that works well. I use the flight pack battery balance tap for pwr. I used it a good while ago to activate an onboard camera. I set aside then just found it again so I tried for light and works.
http://www.dimensionengineering.com/products/picoswitch

 

[jaybird]

A brushed motor speed control works great. Can set it up on a knob or slider and adjust like a dimmer.

 

[Rotortrash]

http://www.ebay.com/itm/331002625132?_trksid=p2055119.m1438.l2649&ssPageName=STRK:MEBIDX:IT

I have a couple of these now. It works very well. I'm using a 3 cell lipo in one of the installations, it handles the voltage just fine.

 

[Xpress]

http://www.ebay.com/itm/331002625132?_trksid=p2055119.m1438.l2649&ssPageName=STRK:MEBIDX:IT

I have a couple of these now. It works very well. I'm using a 3 cell lipo in one of the installations, it handles the voltage just fine.

That's actually perfect, and inexpensive too.

 

[Decal Dennis]

They might have what your looking for here: http://www.bphobbies.com/view.asp?id=V819427

I was going to buy one to remote ignite and M80 on a foamie plane I hate!! LOL

 

[CatalinaWOW]

I've had great luck with these:

http://www.hansenhobbies.com/products/onboardacc/ers/

Don't remember the voltage limits, but I use them with 3 cell lipos so they should handle a lot of peoples needs.

 

[Bartman]

Check out Pololu.com also, they make a wide variety of small electronic doo-dads and their prices are very reasonable.