gyro
GSN Contributor
3dhs 92" Edge 540
- Thread starter gyro
- Start date
- Status
djmoose
70cc twin V2
The arm isn't removable like on a DLE.
You have to pry it off and buy another:
http://store.aztechaeromodels.com/s...product&filter_name=arm&page=5&product_id=449
I just had to do the same thing on my Zenoah G38
gyro
GSN Contributor
:facepalm: even IF I could get it off, then issue is there is NO extra clearance inside the engine housing for a longer arm:
djmoose
70cc twin V2
How about on the opposite side of the carb where the other end of the throttle rod extends?
gyro
GSN Contributor
Is it not possible to just use it the way it is?
Brian Yak Dude
50cc
I would say use it how it is. The resolution IMO won't be terribly noticeable. I've been using stock arms for years with no trouble.
If you'd like to get a longer arm on it, try switching to the other side of the carb to find more clearance if possible, and proceed with the instructions about the arm posted earlier.
Just my .2
Thanks
Brian
If you'd like to get a longer arm on it, try switching to the other side of the carb to find more clearance if possible, and proceed with the instructions about the arm posted earlier.
Just my .2
Thanks
Brian
djmoose
70cc twin V2
It's definitely possible...you're just going to have a teeny tiny amount of throttle servo throw.
gyro
GSN Contributor
Inner hole of the servo arm and a well made throttle curve?
djmoose
70cc twin V2
That sounds like a plan!
gyro
GSN Contributor
Cool, that's what I've done on my other engines when necessary, but this one had me a little worried. Thanks for the suggestions!
- Status