• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!
  • Unless you are a paid advertiser NO more posting advertisement in the individual vendor forums. You may post in the Manufacturer's Announcements section only but only ONCE a month unless your a paid advertiser.

Building of the 30cc Slick 540 from Redwing RC!!!

Jwmav528

Jwmav528

70cc twin V2
Next up, I installed the fuel system, throttle linkage, and choke rod. uploadfromtaptalk1382884012794.jpguploadfromtaptalk1382884039229.jpguploadfromtaptalk1382884066084.jpguploadfromtaptalk1382884109146.jpguploadfromtaptalk1382884132444.jpguploadfromtaptalk1382884293318.jpg
 

Attachments

  • uploadfromtaptalk1382884277486.jpg
    uploadfromtaptalk1382884277486.jpg
    60.1 KB · Views: 360
gyro

gyro

GSN Contributor
Jeff, you might need to add some foam between the ignition and the firewall to cushion from vibration.
 
Jwmav528

Jwmav528

70cc twin V2
You can't see it in the picture but it's there. I cut some from the foam that the engine came packed in and I put three or four layers of it.
 
Jwmav528

Jwmav528

70cc twin V2
The cowling fitted with everything in the engine compartment installed. The choke rod is accessible and everything. I went with a Redwing prop and 3.5" carbon fiber spinner. So far, everything on this plane came from Redwing rc. They are very extensive in their product offerings.
uploadfromtaptalk1382886205761.jpguploadfromtaptalk1382886215597.jpg

Next up, came the electronics. So pictured are the switch, battery installed on the recommended cg (wingtube), tach, optokill, and receiver. The satellite rx is below the rudder servo.
uploadfromtaptalk1382886491770.jpguploadfromtaptalk1382886512858.jpguploadfromtaptalk1382886524652.jpguploadfromtaptalk1382886552661.jpg

Now does anyone have suggestions on how to remove all that Sharpie?
 
Jwmav528

Jwmav528

70cc twin V2
Due to the limited size of my shop (basement), I saved the wings for last. I'm sure most of you have installed this type of wing servo in the past so I didn't go into too much detail. Be sure to note the turnbuckle type pushrods to adjust their length. uploadfromtaptalk1382886926731.jpguploadfromtaptalk1382886936795.jpg
 
Jwmav528

Jwmav528

70cc twin V2
Here she is! Ready for maiden! uploadfromtaptalk1382887025168.jpg

There aren't graphics on it yet for two reasons.
1. I promised photos to Redwing on the ground and in the air.
2. I'm superstitious and won't put "the pretty stuff" on until I have a successful maiden.

The pretty stuff in this case will be a CF xion prop and custom "Monster Energy" graphics from Gyro.
 
Last edited by a moderator:
Jwmav528

Jwmav528

70cc twin V2
Almost forgot, if you're friends with me on Facebook then I'll be happy to tell you that it does in fact fit in my car with a whole 1.5" to spare. :D
 
You must log in or register to reply here.
Top