OK, so now on to laying down some covering. I start out by doing the end caps first, I give myself about a 1/8th inch overlap so that I have something to attached the covering and pull on it from the opposite side. Oh!! Right before I put the piece over the wing I again clean it with a rag damped with alcohol, this will pick up any bumps or trash that later my look like Mount Everest, which drives me crazy. Another tip is to pull the clear plastic from the covering while is on top of the wing, but make sure you do it slow and do not allowed the monokote to get wadded up, not sure how to explain that better. It will get creases on it and will show up unless you heated very hot and pull on it.