Extreme Flight 76/83" MXS

[3dmike]

Motor installed

View attachment 26919

Looking good!!! And man that's some serious throws!

What stand are you using there for building?

 

[hone]

Motor installed

View attachment 26919

What a coincidence! I just mounted my motor too
I'll be taking it back off to drill the firewall for throttle linkage and such though.

 

[Enterprise]

Thanks to a tip from "the boss", I used double sided tape to set the perfect spinner gap. The stand is the one EF sells. Very handy. It has 3 different size airplane cut outs.

Just model props has dropped the ball and not shipped a order I made on Tuesday. Have to use either a 21x10 xoar or this hunk of APC.

http://www.extremeflightrc.com/store/index.php?main_page=product_info&cPath=7_9&products_id=91

 

[hone]

Thanks to a tip from "the boss", I used double sided tape to set the perfect spinner gap. The stand is the one EF sells. Very handy. It has 3 different size airplane cut outs.

Just model props has dropped the ball and not shipped a order I made on Tuesday. Have to use either a 21x10 xoar or this hunk of APC.

http://www.extremeflightrc.com/store/index.php?main_page=product_info&cPath=7_9&products_id=91

View attachment 26929

That's an awesome spinner gap. Great tip.

My tech aero ibec came today so I just dropped it in really quick. I'm going to need to pick up some of that snake skin/mesh covering for all my wiring.

 

[3dRCparts.com]

what size spinner?

 

[hone]

what size spinner?

The one I threw on there was a 3 inch from my 78 extra. I need to buy a new spinner though since the bolt pattern is different. I'm thinking of looking for a 3.5 inch spinner though.

 

[3dRCparts.com]

what is the bolt pattern? da50/60?

 

[hone]

what is the bolt pattern? da50/60?

The only thing I've seen people mention it was the same as is the mintor 38.

I need to get a drill guide or I may just carefully use the prop washer and my drill press.

 

[Enterprise]

It is the same as the Mintor 33/38. I actually had one of these and had some props and a spinner left over as well as the drill guide. It is the same spacing as the DA-50, but with M4s instead of M5s. PSP sells the drill guide.

I am using a EF 3" spinner for now. I ordered a slightly larger one from Falcon that has the cooling openings and should fit perfect as the 3" is slightly too small.

 

[3dRCparts.com]

thanks