The 'What did you do in your workshop tonight?' thread

[Snoopy1]

Nick mentioned Extreme Flight. Below is a video and photos of a larger Muscle Bipe which should be out soon.

Thanks for that but the two @AKNick is showing the two planes that are different, the green one just perfect in my eyes.

 

[AKNick]

Looks exciting been looking for a biplane. Looked around and found nothing. Can you give some clue were to look.

They are Prototypes, I think the 6S electric will be on the market first to gauge product demand... so you cannot buy it quite yet. Everyone has been pleading Extreme Flight to create an aerobatic bipe... finally the wait is almost over.

 

[Snoopy1]

I believe it is done every time I look at it a can make a change or improve it so just stop looking. Up to 114 detailed parts. Just have send it to the cutter to check it out and give me quotation to supply all the wood and parts. All the parts are detailed so that it all can be made from 3 by 36 inch sheets.

 

[AKNick]

Made a video about the tapered tire tool... I just watched it... and realized at the end I helped Somone not Someone. My editor doesn't have spell check LOL!! But hey! Maybe the someone it helps is names Somone!

 

[pawnshopmike]

Made a video about the tapered tire tool... I just watched it... and realized at the end I helped Somone not Someone. My editor doesn't have spell check LOL!! But hey! Maybe the someone it helps is names Somone!

Great job brother.

 

[-Rick-]

Made a video about the tapered tire tool... I just watched it... and realized at the end I helped Somone not Someone. My editor doesn't have spell check LOL!! But hey! Maybe the someone it helps is names Somone!

That is such a good idea! Works so well!

 

[acerc]

Don't know where the thread is, not going to say much other than the base top wing is covered.

 

[WMcNabb]

Don't know where the thread is, not going to say much other than the base top wing is covered.

Nice! I assume you’re using Scale Stits, aka Poly Lite?

 

[acerc]

Nice! I assume you’re using Scale Stits, aka Poly Lite?

Yes...

 

[Snoopy1]

Installed the 100 on the test stand. Flipped the propeller till the fuel interred the carburetor. Closed the choke two flips it burped. Open the choke one flip and it ran. Let it run at about 2300 rpm for a minute then accelerated to full throttle for 3 seconds and then Dow to idle. It just sat there and idled great. Couple short throttle bursts and it accelerated great. Shut it down and will installed soon, that all of five minutes and I was done, great engine looks like a winner.