3D Viper-ST 100-120cc scratch build......it continues!

[ericb]

Installing the control horns. Place them so the hole is directly over the hinge line and cut the covering. Use epoxy to install. I install a ball link to keep them straight and in the correct position.

 

[Wacobipe]

What control horns are those....I like those a Lot!

 

[BalsaDust]

Those are prolly the control horns that Terry cuts himself.

 

[ericb]

Those are prolly the control horns that Terry cuts himself.

Nailed it.

 

[Terryscustom]

Yes, we CNC those out. Rick still has two kits on hand that will include those horns and blocks free of charge:

 

[ericb]

I was able to get the SFG's covered tonight. I did blue on the inside and white on the outside. The end of the wing is blue and that is why the blue is on one side. I like it to match and not be such a harsh transition

.

 

[ericb]

I drilled and tapped the wingtips for the SFG's, but don't have any foam safe CA left so I will get some tomorrow. Also need some more bonded washers. I will use bonded washers for spacers also, so there will be a gap where the pic shows none.

 

[Terryscustom]

Cool, let me know if the bonded washers don't leave enough space for you and we can laser you a spacer for the wing tips.

 

[ericb]

Cool, let me know if the bonded washers don't leave enough space for you and we can laser you a spacer for the wing tips.

Will do.

 

[tylerzx9r]

Nice looking Pair of Wings!