• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

3D 30cc hazzbro extra

D

daman691003

70cc twin V2
Lol I really am lost with that question. Also what down thrust and offset u guys using. Or just zero. I got my engine and setvos are ordered. Setvos will be here tommorow. I got dle30
 
Hazzbro

Hazzbro

30cc
Velco straps that wrap the tank will work. I use two straps that go through the fuse and wrap the fiji tank front and back.

Here's a pic of the wing area I am describing.
upload_2015-2-22_16-10-25.png
 
D

daman691003

70cc twin V2
Yes I did the 3rd. And it was because of a mistake I made. I had to cut sheeting out to fix a bad glue joint. The doubler for the wing wasn't sitting square. My fault.
 
Hazzbro

Hazzbro

30cc
daman691003 said:
Where does everyone put batteries and receaivers. I rather not have hatch in wing.
Click to expand...


In the wing.. :) You really want them there for balance. You can just put a switch and charge jack in one wing. I don't usually put hatches in mine. I use a small lipo for ignition with this: http://www.wrongwayrc.com/index.php?route=product/product&path=73_65&product_id=159

I also use one A123 battery setups. Are you going to run one bat for receiver and ignition? If so, there are several power options to allow you to do that. Wrongway sells a simple diode that isolates the receiver and steps the voltage down. http://www.wrongwayrc.com/index.php?route=product/product&path=75_95&product_id=154
 
Hazzbro

Hazzbro

30cc
Getting ready for a long business trip so my replies will be really slow....

One thing you should do...put all of your tail, ignition, and throttle wires in the fuse now. You can easily cover each side with them taped up in the fuse. Makes life a lot easier!

Looking great!
 
You must log in or register to reply here.
Top