• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!
  • Unless you are a paid advertiser NO more posting advertisement in the individual vendor forums. You may post in the Manufacturer's Announcements section only but only ONCE a month unless your a paid advertiser.

3DHS 58" Edge 540

quadracer

quadracer

100cc
Did you recently set this plane up? I'd make sure the endpoints on throttle are correct, to make sure you're actually sending full throttle signal at full stick. I've been known to do that before...... :)
 
njswede

njswede

150cc
quadracer said:
Did you recently set this plane up? I'd make sure the endpoints on throttle are correct, to make sure you're actually sending full throttle signal at full stick. I've been known to do that before...... :)
Click to expand...

I just got back from the field and my maiden of a very similar setup. Here's my setup:

Leopard 5055 720kv.
Land Power 85A OTPO ESC
Gens Ace 4000mAh 4s with maybe 50 flights on them.
APC 15x7E
1096W @ 72A

Impressions:
Definitely not a rocket ship, but adequate power for 3D flying. Good vertical. EXCELLENT pop tops! Pulls out OK from hovers. However, towards the end of each flight (about 5:30) the pull-outs were a bit lackluster but not unsafe. I will set my timer to 5:00 and obey it strictly.

I may switch to a 5s or 6s setup, but for what I'm doing now it's fine.
 
Last edited by a moderator:
gyro

gyro

GSN Contributor
Edge maiden today!!

ImageUploadedByTapatalk1358618415.847995.jpg
 
gyro

gyro

GSN Contributor
Maiden complete... Can't wait to get another battery in. Pop tops are AMAZING!! Comparable to my 70" Slick and 64" MXS.
Very impressed!
 
You must log in or register to reply here.
Top