Scale Bud Nosen 1/4 Scale Cub?

[dhal22]

https://www.pipercubforum.com/

Thanks for that link. Got to get back on my Cub build asap.

 

[TonyHallo]

Had snow flurries last night, building season has officially began in South Western Pennsylvania!

 

[Stevendavis]

Had snow flurries last night, building season has officially began in South Western Pennsylvania!

Yep, we had some sub zero temps last week, and winds have been unpleasant!

 

[dhal22]

All shorts and t shirt this fall (until today). Chilly this morning.

 

[Stevendavis]

It sure has turned here in Eastern Idaho!
I did a dry run on the ribs, just to make sure I've got all the holes drilled that I need. I'm going to go ahead and make the top of the wing tip flat with the top of the wing, as the plans indicate. I think I'm ready to start gluing! I also cut some servo mounts out of 1/4 X 1/2" spruce. Also cut a new full length trailing edge.

 

[WMcNabb]

It sure has turned here in Eastern Idaho!
I did a dry run on the ribs, just to make sure I've got all the holes drilled that I need. I'm going to go ahead and make the top of the wing tip flat with the top of the wing, as the plans indicate. I think I'm ready to start gluing! I also cut some servo mounts out of 1/4 X 1/2" spruce. Also cut a new full length trailing edge.

I love it when a plan, or a plane, comes together!

 

[Stevendavis]

I love it when a plan, or a plane, comes together!

Me too!

 

[Stevendavis]

A little update. Glue is applied!

 

[Stevendavis]

Here's the wing bolt method.

 

[Stevendavis]

Slow progress as I'm trying to figure every thing out as I go. I built some doublers for the servo rails, put a couple gussets along the trailing edge. I also installed a ply backer on the leading edge where I might install a light kit. Went all the way out with the sheer webs, as the bottom spars are cut at the 3rd rib from the end.